|
| |
Instructions
-
BEFORE
OPERATING
-
The
KP Pneumatic Tool has been thoroughly tested and shipped complete
but DO NOT attempt to operate without carefully reading the following
instructions.
-
The
air line must have automatic filtering and lubrication. The compressed
air to the motor must be free of moisture and dirt or damage will occur.
The equipment must be capable of handling at least 43 cu. ft. of air per
minute at 70 -100 lbs. air pressure.
-
Connect
to air line, using a minimum 3/8" inside diameter
hose.
-
OPERATING
INSTRUCTIONS
-
Wear
safety glasses and hearing protection.
-
Grasp
both handles and raise front of tool from surface. Then squeeze trigger.
Allow cutters to come up to speed before applying to surface.
-
Using
both hands, guide tool in a forward and back motion to assure complete
coverage. Let weight of tool do the work. Apply
only enough pressure to front head of tool to keep tool from bouncing
off the surface. Excessive pressure will slow down motor speed and cause
damage to motor, gears, and cutter bundles.
-
SURFACE
AND MAINTENANCE INSTRUCTION
DEPTH ADJUSTMENT:
|
